Home >> Machinery >> Tube Mills / Pipe Mills >> Small Diameter Tube Mills

NEW FMS 76-65 H.F. TUBE MILL

We are pleased to offer for your consideration the following new tube mill: Ref. No. M917

Designated Model: FMS TM 76-65

Hand of Operation:                             Right to Left
Materials:                                            Low Carbon Steel, Yield Strength 50,000 PSI
Strip Width Range:                             40 mm to 240 mm
Strip Thickness:                                   Max. .140” (3.5 mm)
Tube OD Range:                                 Round:  1/2” to 3” (76.2 mm)
Rec. & Square:                                    Accordingly
Tube Wall Range:                               Max. .140” (3.5 mm)
Mill Speed:                                          Maximum – 300 FPM for small diameter and light gauge tubing
Supply Voltage: 480 Volt, 3 Phase, 60 Hz
Control Voltage: 110 V Single Phase, 60 Hz

EQUIPMENT SUMMARY

FMS Double 10,000 Lb. Uncoiler
Double Arm Type
Load Capacity: 5 Metric Tons (11,000 Lb.)
Strip Width: Max. 12” (305 mm)
4-Leave Hydraulic Wedge Type Mandrel Expansion

FMS Double 10,000 Lb. Uncoiler (Cont.)
Manual Mandrel Turning
Manual Base Rotation with Automatic Position Stop Mechanism
Two Stage Air Brakes, Low Drag and High Tension
Full Back Plate with Peek Holes
Coil Keepers: 4

FMS SWO-250 Semi-Automatic Shear End Weld Unit
Portable, Push-Away Type
Max. Strip Width: 10” (250 mm)
Max. Strip Thickness: .140” (3.5 mm)
Hydraulic Clamps
Hydraulic Shear
Automatic TIG Weld