Home >> Machinery >> Tube Mills / Pipe Mills

NEW FMS TM LM 76-63 H.F. TUBE MILL:

We are pleased to offer for your consideration the following new tube mill: Ref. No. M892

Designated Model: FMS TM LM 76-63

Hand of Operation:                     Left to Right
Materials:                                     Low Carbon Steel, Yield Strength 50,000 PSI
Strip Width Range:                     40 mm to 240 mm
Strip Thickness:                           Maximum – .130” (3.5 mm)
Tube OD Range:                         Round – 1/2” to 3” (76.2 mm)
Rec. & Square:                            Accordingly
Tube Wall Range:                        Maximum – .135” (3.4 mm)
Mill Speed:                                  Maximum - 265 FPM (80 MPM) for small diameter and light
                                                     (Thru 2 Speed Gear Reducers) gauge tubing
                                                     Max. 150 FPM for Tubing 3”OD x .135” Wall
Supply Voltage:                           460 Volt, 3 Phase, 60 Hz
Control Voltage:                          110 Volt, Single Phase, 60 Hz

EQUIPMENT SUMMARY

FMS UCD -5 PR Double Arm Uncoiler:
Double Arm Type
Load Capacity: 5 Metric Tons (11,000 Lbs.) on Each Arm
Coil OD: Max. 72”
Coil ID Range: 18” to 22”
Strip Width: Max. 12” (305 mm)
4-Leaf Hydraulic Wedge Type Mandrel Expansion
Manual Strip Feed-Up Two Stage Air Brakes, Low For Drag and High For Brake; 
      Equipped with Manual Brake Release Switch for Easy Strip Threading
Hydraulic Powered 180 Degree Base Rotation with Automatic Pneumatic Position Stop and
      Locked
Full Back Plate with Peek Holes
Coil Keepers: 4 on Each Arm